Matthew Farrow Attends Key IMechE Accredited Courseby Atlantic Pumps Admin
Above: Matthew Farrow outside the Institution of Mechanical Engineering
Atlantic Pumps Design Engineer Matthew Farrow is currently attending a three-day Institution of Mechanical Engineering accredited Geometric Dimensioning and Tolerancing (GD&T) course in London.
This specific course focuses on BS 8888 which brings together all the international standards to correctly prepare product specification documents (engineering drawings). Here at Atlantic we use ASME-Y14.5, which is functionally very similar, hence the training is directly applicable.
It is important for our design engineers to be skilled in this way because it is the only perfect method of communicating how parts and assemblies should be. Therefore, each part is guaranteed to fulfil the design intent - all functional parts are accepted and all non-functional parts are rejected, and all our parts perfectly fit together in our assemblies.
With our engineering department set up in this way, we allow ourselves to find and trace errors, operate at the highest possible efficiency without sacrificing any quality and be massively scalable in the future.
- Coal washing
- Filter press
- Mine effluents
- Sand processing
- Silt pumping
- Thickener underflow
- Wash plant feeds
- Water treatment
- Brick & Concrete Block Manufacturing
- Large scale manufacturing
- Quarrying & Aggregates
- Ready mix concrete
- Sustainable Energy